I have the Corona DYI (with CR8D Receiver) instaled in my Turnigy 9X TX. If I bind the TX when it´s too close from RX, I heard a beep from ESC and servos stop to work. Is it normal?
Paulo
Corona CR8D Receiver issues
2 posts
• Page 1 of 1
Corona CR8D Receiver issues
by pm-peixoto » Sat Sep 04, 2010 7:19 pm
Hi,
I have the Corona DYI (with CR8D Receiver) instaled in my Turnigy 9X TX. If I bind the TX when it´s too close from RX, I heard a beep from ESC and servos stop to work. Is it normal?
Paulo
I have the Corona DYI (with CR8D Receiver) instaled in my Turnigy 9X TX. If I bind the TX when it´s too close from RX, I heard a beep from ESC and servos stop to work. Is it normal?
Paulo
- pm-peixoto
- Posts: 8
- Joined: Sat May 29, 2010 1:38 am
Re: Corona CR8D Receiver issues
by RCModelReviews » Sat Sep 04, 2010 9:00 pm
If you are talking about distances of just a foot or two then that's called swamping. I have noticed it on some 2.4GHz systems and earlier versions of the FlyDream suffered badly from this. I hadn't noticed it being too much of an issue with the Corona though -- but I understand there have been some revisions to the Corona product recently.
RCModelReviews.com, just the facts.
-
RCModelReviews - Posts: 2120
- Joined: Tue May 04, 2010 3:40 am
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 30 guests