Hello mr Bruce, first post of me here at RC Model Reviews about Corona DSSS DIY 2.4 GHz.
The problem is as such; on October 9, 2010, at
www.gooieneemlandvvm.nl one of two planes crashed while one of another Corona DSSS DIY-set was switched on.
Duplicating this event on the ground did work once, thereafter it didn't.
These sets are in radios that use + 8 cells or 3S1P LiPo's. Corona states that initial binding is not be be done over 3 seconds (the transmitter) and if this event
is to happen again, to press the master-bind button for over 3 seconds, to be certain that the ID's are different... (?)
Seems like an identical ID, but what caused it ? Is it the <3 seconds of initial binding ? Or perhaps over Voltage on the PPM board ?
Perhaps interesting to know, what is the total number of ID's on Corona DSSS ? Obviously one Corona DSSS that interferes another raises this question, maybe you've heared
about these problems or have any clue ?
Regards and awaiting your view on this,
Marcel(air)