F/S button location on TFR8 2.4 GHz Rcvr

Here's an area where you can ask any kind of question about RC models and find a whole lot of useful information to help you get started.

F/S button location on TFR8 2.4 GHz Rcvr

Postby jsham5 » Mon Nov 01, 2010 4:07 pm

I finally received the TFR8 2.4GHz, FASST compatible, FRSKY receiver yesterday. I see the LED lights on top of the unit but am not sure where the F/S button is located for Binding to my Futaba 6EX 2.4GHz transmitter.

Also, is the top pin in each channel connected to the + or - lead, assuming the middle pin is for signal? In Futaba it would be negative.

Jsham5
jsham5
 
Posts: 1
Joined: Sun Oct 31, 2010 7:38 pm

Re: F/S button location on TFR8 2.4 GHz Rcvr

Postby RCModelReviews » Tue Nov 02, 2010 7:35 am

The row of pins which are closest to the edge of the board is the negative.

The FS button is the only button on the receiver -- it's the same one used for binding.

Here's how to change, according to the instructions:

Turn the transmitter off, connect the battery to the receiver, press the F/S button on the receiver for 6 seconds and release. The red LED will flash quickly in HS mode and slowly in FS mode
RCModelReviews.com, just the facts.
User avatar
RCModelReviews
 
Posts: 2120
Joined: Tue May 04, 2010 3:40 am


Return to For Beginners (if you're just getting started in RC)

Who is online

Users browsing this forum: No registered users and 1 guest

cron