Corona CT8Z 2.4 GHz to Futaba FF6

Here's an area where you can ask any kind of question about RC models and find a whole lot of useful information to help you get started.

Corona CT8Z 2.4 GHz to Futaba FF6

Postby mandril » Thu Dec 30, 2010 9:52 am

Hi mates!!

I have bought a Corona CT8Z 2.4 GHz, and I need to install it on a Futaba FF6 (T6EXHP). The problem is that I don´t have absolutely anything (electric schemes, plans...), and I don´t know where to start.
Can somebody help me?.

Thank you very much.

Best regards, and happy New Year.
mandril
 
Posts: 1
Joined: Thu Dec 30, 2010 9:39 am

Re: Corona CT8Z 2.4 GHz to Futaba FF6

Postby pushinoldrc » Fri Dec 31, 2010 11:51 am

I have not modified a 6EX, but have done a couple of 6XAsupers. You can utilize the trainer switch as a source of the PPM signal, as it is routed there when it leaves the main board, or pick it up directly from the trainer port. If you need more information, I can post picks of one of my mods. Be sure that you have the transmitter in PPM (FM) mode before trying to bind your receiver. A digital multimeter will read approx. .5vdc on the PPM stream.
Landing is one aerobatic maneuver that MUST be perfected!
User avatar
pushinoldrc
 
Posts: 71
Joined: Tue Sep 14, 2010 10:00 pm
Location: N.E. Georgia, USA


Return to For Beginners (if you're just getting started in RC)

Who is online

Users browsing this forum: No registered users and 2 guests