Hi,
If anyone's installed one of the Frsky two-way DIY modules, DHT, I'd be interested in their solutions for mounting the switch and LED panel. It doesn't look straightforward to make it easily usable.
The DIP switches and the bind/range check button are pretty much level, so could be accessible through appropriate cut outs. The LEDs, just below where its says "D1" are surface mounted on the PCB, so I'm undecided as to how to make them visible. I think I might try making a clear panel, with cut outs for the switches, and see if the LEDs are going to be visible enough through the plastic.
Any other ideas welcome!
Thanks, Tony S