Hello,
I have a Multiplex Funcub plane. This has a wingspan of about 1.4meters, and has 4 servos in the wing.
To transport this in the car, i typically unfasten the wing, and twist it so it is parallel to the fuselage, all wires still attached. I still cannot fit it in the trunk of my car though.
I was thinking that i should devise some different way to do my servo leads, so I can easily attach and detach the wing easily. Anyone have any good experiences and ideas? I was thinking shortening all the leads to end at the same place, about 5-10 cm longer than "to the middle of the wing", color code them with shrink wrap, and add new leads from Rx up to the same place, also with color coding.
If a "multi servo" connector block exists, that might be something to look into as well..
Today its wired like this:
Aileron servos, extended mid wing, connected directly to the Rx
Flap Servos, original servo leads about 4 cm longer than "the middle of the wing", attached to a Y harness, then to the Rx.
Regards