Turnigy 9x DIY evolutionary path - comments?

Here's an area where you can ask any kind of question about RC models and find a whole lot of useful information to help you get started.

Re: Turnigy 9x DIY evolutionary path - comments?

Postby pldb64 » Mon Nov 07, 2011 2:47 am

rogueqd wrote:You do not need step 3 if you are going to do step 4.


Duly noted - Telemetry DIY is now enroute (slow boat etc) ... so step 3 now deleted from the plan

rogueqd wrote:I would rate the Smartieparts board as C-2, being easier than the resistor mod, and the er9x software as A-novice B-8 with the original 9x software being A-almost useless B-2. The er9x software is more complex but also more intuitive than the original software, so I'd recommend upgrading as soon as you want to program more than one switch, saving yourself the headache of learning the original which can only ever program two switches anyway.


Looks like there is a lengthy delay on these boards at the moment and demand is growing daily :-) ... a good problem for the supplier i guess. :-)

Thanks everyone for your comments & thoughts.
Turnigy 9x, FrSky 2-Way/Telemetry DHT DIY, Smartieparts BRD, ER9x FW
AXN-Floater (stock esc, motor & prop, HK orange 9g servos)
pldb64
 
Posts: 156
Joined: Fri Nov 04, 2011 3:09 am
Location: Sydney, australia

Previous

Return to For Beginners (if you're just getting started in RC)

Who is online

Users browsing this forum: No registered users and 3 guests

cron